IJREE – Volume 4 Issue 4 Paper 5

FLEXIBLE DISTRIBUTION NETWORKS USING DIRECT MMC WITH SIX BRANCHES

Author’s Name :  S Basha | M L Dwarakanand | M Rama Subbamma

Volume 04 Issue 04  Year 2017  ISSN No: 2349-2503  Page no: 23-28

12

Abstract:

This paper presents a complete analysis of a direct ac-to-ac modular multilevel converter (direct MMC) applied in medium-voltage distribution networks through the soft-open-point concept. The direct MMC is capable of bidirectional power flow between two feeders at any power factor, even when the feeders have different nominal voltages and operate with a phase-shift angle or unbalanced voltages. The converter has six branches, each one composed of full H-bridges cells connected in series to generate a multilevel voltage waveform, to share the blocking voltage of the power switches and to have fault-tolerant operation. This paper presents a suitable control scheme and provides a discussion about the capabilities and limitations of the converter, the capacitor voltage balance control, the efficiency, and the power-loss mitigation at various operation points. Simulation results and power-loss calculations are presented for a three-phase 11-kV 16-MVA direct MMC with 10 H-bridge cells per branch. The direct MMC is simulated in a distribution network to demonstrate the features of the converter and control under various operation conditions, including grid faults.

Keywords:

AC-AC Power Converters, Direct Power Conversion, Grid-Connected Converters, Matrix Modular Multilevel Converters, Power-Flow Controller, Soft Open Point (SOPs)

References:

  1. M. Cavlovic, “Challenges of optimizing the integration of distributed generation into the distribution network,” in Proc. IEEE 8th Int. Conf. Eur. Energy Market, May 2011, pp. 419–426.
  2. N. Saadat, S. S. Choi, and D. M. Vilathgamuwa, “A series-connected photo voltaic distributed generator capable of enhancing power quality,” IEEE Trans. Energy Convers., vol. 28, no. 4, pp. 1026–1035, Dec. 2013.
  3. M.-C. Alvarez-Herault, D. Picault, R. Caire, B. Raison, N. HadjSaid, and W. Bienia, “A novel hybrid network architecture to increase DG insertion in electrical distribution systems,” IEEE Trans. Power Syst., vol. 26, no. 2, pp. 905–914, May 2011.
  4. W. A. Omran, M. Kazerani, and M. M. A. Salama, “Investigation of methods for reduction of power fluctuations generated from large grid connected photovoltaic systems,” IEEE Trans. Energy Convers., vol. 26, no. 1, pp. 318–327, Mar. 2011.
  5. J. M. Bloemink and T. C. Green, “Increasing distributed generation penetration using soft normally-open points,” in Proc. IEEE Power Energy Soc. Gen. Meeting, Jul. 2010, pp. 1–8.
  6. J.M. Bloemink and T. C. Green, “Increasing photovoltaic penetration with local energy storage and soft normally-open points,” in Proc. IEEE Power Energy Soc. Gen. Meeting, Jul. 2011, pp. 1–8.
  7. A. Kechroud, J. M. A. Myrzik, andW. Kling, “Taking the experience from flexible AC transmission systems to flexible AC distribution systems,” in Proc. IEEE 42nd Int. Univ. Power Eng. Conf., Sep. 2007, pp. 687–692.